Introduction


The following steps will walk you through the process of setting up a bridge from LiveDDM to Owandy QuickVision. 


These steps must be completed on each workstation that is running LiveDDM with Owandy installed.



As of LiveDDM v6.2.49 the Owandy Bridge is included in the installer.



Steps


  1. Install LiveDDM v6.2.49 or higher
  2. Open LiveDDM and navigate to User -> Terminal Settings -> Imaging
  3. Under Primary Imaging Software, choose Owandy QuickVision from the Imaging Software drop down.  You do not need to set the Imaging Software Path as it is not used.   The Path to Owandy is derived from the following Registry Key:  HKEY_LOCAL_MACHINE\SOFTWARE\Julie\QuickVision
  4. Click the green check mark to save the Imaging settings


To Test:


  1. Select an active Patient and then click the Launch Bridge icon
  2. Owandy QuickVision should launch with the currently selected Patient